← 返回关西 KANSAI品牌页

TANKCARE PC-50 酚醛环氧漆PC-50

选型速览

TANKCARE PC-50 酚醛环氧漆PC-50 属环氧漆。vessels. 一种底面合一涂料作为储罐和容器的内壁衬里使用。是一种双组份厚浆型环氧酚醛储罐涂料。优异的耐化学品和耐溶剂性能 Excellent high-build applicability 极好的厚涂施工性能 Excellent anti-abrasion and impact resistance 极好的耐磨损和耐冲击性能。本页参数:体积固体份 70 ± 2%、干膜厚度 100-300 微米/道、理论涂布率 0.296 千克/平方米/150 微米。

以上内容整理自原厂说明书与本站参数表;选型、配套与货期请联系我们确认。

体积固体份70 ± 2%
干膜厚度100-300 微米/道
理论涂布率0.296 千克/平方米 /150 微米
VOC300 克/升,符合欧盟溶剂排放指令2004/42/EC,j 子类别
密度/比重—
组份数双组份
闪点25℃以上
稀释剂环氧稀释剂#20
混合比Base/Hardener=9/1(by weight)

按分类浏览同类型号本型号属于:环氧漆、酚醛漆

TANKCARE PC-50酚醛环氧漆PC-50

PRODUCT DESCRIPTION

A two pack hi-build epoxy novolac tank coating.

产品简介

是一种双组份厚浆型环氧酚醛储罐涂料。

RECOMMENDED USE

As a protective primer-finish coat can be used for internal lining of tanks and

用途

vessels.

一种底面合一涂料作为储罐和容器的内壁衬里使用。

COMPLIED STANDARDS

Complies with SY/T 0319-98, SY/T 0320-2010

符合标准

符合钢制储罐液体环氧涂料内防腐层技术标准SY/T 0319-98、钢制储罐外防 腐层技术标准SY/T 0320-2010

FEATURES

Excellent resistance to extensive range of solvents and chemicals

产品特性

优异的耐化学品和耐溶剂性能

Excellent high-build applicability

极好的厚涂施工性能

Excellent anti-abrasion and impact resistance

极好的耐磨损和耐冲击性能

PHYSICAL PROPERTIES

基本数据

ColorGrey and White
颜色灰色和白色
Volume Solids 体积固体份70±2 %
VOC300g/L,accord with EU Dircrtive2004/42/EC,subcategory j
挥发性有机化合物含量300 克/升,符合欧盟溶剂排放指令2004/42/EC,j 子类别
Flash PointGreater than25℃
闪点25℃以上
Film thicknessDry 100-300 microns/coat Wet : 125-375microns/coat
涂装膜厚干膜:100-300 微米/道湿膜: 125-375 微米/道
Theoretical Coverage0.296Kg/m2/150 microns
理论涂覆率0.296 千克/平方米/150 微米

Practical coverage depending on surface conditions, environment, applications, etc.

实际涂覆率与表面处理, 外界环境, 施工方法等多种因素有关。

SURFACE PREPARATIONRemove salt and other water-soluble contaminants by fresh water.
表面处理用清水冲去盐份及其它水溶性污物。

Remove oil and grease with suitable detergent or solvent(SSPC-SP 1).

依照SSPC-SP1 溶剂清洗标准除去油脂。

Remove rust, mill-scale and other loose material completely by abrasive blasting.

用喷砂方式除去铁锈、氧化皮等达到ISO Sa21/2(SSPC-SP 10)或更好。

All surface to be coated should completely clean, dry and free from contamination.

涂漆前确认表面清洁干燥无灰尘。

APPLICATION

施工

Application Temperature 施工温度10℃-40℃
MixingCombine Base with Hardener, mix thoroughly with power agitator
混合混合主剂与固化剂,使用动力工具搅拌均匀
Mixing RatioBase/Hardener=9/1(by weight)
混合比例主剂/固化剂=9/1(质量比)
Pot life5℃20℃30℃
混合使用期5hrs4hrs3hrs
Application MethodsAirless spray, air spray
施工方法无气喷涂、空气喷涂

Airless spray 无气喷涂

Nozzle tip喷嘴尺寸0.43mm-0.53mm
Nozzle pressure出口压力≥10Mpa
Thinning ratio稀释比率0-5% by volume(体积比)

Brush/Roller 刷涂/滚涂 Thinning ratio 稀释比率 5-10% by volume(体积比)

ThinnerEpomarine Thinner #20
稀释剂环氧稀释剂#20
Drying time & Overcoating intervalDrying time & Surface dryDrying time & 指触干燥15℃ 24hrs25℃ 4hrs35℃ 4hrs
干燥时间&涂装间隔Touch dry半硬干燥48hrs24hrs
Min. interval最小涂装间隔48hrs24hrs
Max. interval最大涂装间隔7days
Applied SubstrateBare steel
适用下底材裸钢
Typical topcoatTANKCARE PC-50
适用上涂酚醛环氧漆PC-50

STORAGE

Store in dry, cool condition and away from sources of heat and ignition. Containers

贮存

must be kept tightly closed.

贮存于干燥阴凉的环境中,远离热源及火源。包装桶必须保持封闭。

Shelf life12 months from date of production (25℃)
贮存期限自生产之日起12 个月(25℃)
SAFETY PRECAUTIONSDetail information is given on MSDS.
安全措施详细信息参见化学品安全说明书。

Avoid inhalation of spray mist or vapour.

避免吸入漆雾或蒸气。

Avoid skin and eye contact.

避免接触皮肤和眼睛。

Paint contacted with skin should be immediately removed with water and/or suitable cleanser. Eyes should be flushed with water and seek immediate medical attention.

如果油漆接触到皮肤,应用温水以及(或者)适当的清洗剂清洗。如果油漆 接触到眼睛,应用大量水冲洗并立即就医。

Since this product contains flammable solvents, keep away from sparks and open flames.

因为产品中含有挥发性溶剂,避开火花和明火。

Application and handling of this product should be in compliance with relevant national regulations.

使用本产品应遵守相关国家安全规定。

DISCLAIMER

The information given on this sheet is to the best of our knowledge and accurate at

提请注意

the time of issuing. Since conditions of use are beyond the manufacturer’s control, information contained herein is without warranty, implied or otherwise, and the suitability of the material for the use contemplated is the sole responsibility of the buyer. The information contained on this data sheet is subject to modification at any time due to our policy of modification and product development.Please check this date sheet is current prior to using the product.

本说明书所提供信息均为目前我方所掌握最全面正确的资料,鉴于产品使用条 件非我方所能控制,此中信息不含担保,即仅在选取产品上对买方负责。由 于我公司产品及生产工艺的不断发展,本说明书的内容也会随时进行更改, 此中所有信息均以我方确认为主。产品使用前,请确认所持说明书为最新版 本。

Issued Date2014/03/02
发行日期2014/03/02

资料以厂商最新版为准,具体以原厂最新 TDS 为准。查看 关西 KANSAI TANKCARE PC-50 酚醛环氧漆PC-50 原厂 PDF 说明书全文。

同品牌相近型号 · 环氧漆、酚醛漆

查看 关西 KANSAI 全部型号

采购与资料

原厂包装规格与批次交期以实际供货为准,可联系我们按项目核算。