EPOMARINE BTD 环氧面漆

选型速览

EPOMARINE BTD 环氧面漆 属环氧漆,作面漆使用。也可作为高性能面漆的中间漆使用。是一种双组份聚酰胺固化的环氧面漆。漆膜强韧 Excellent impact and abrasion resistance properties 极强的耐冲击耐磨损性能 Compatible with epoxy anticorrosive systems 适合同环氧防腐涂料配套 Good workability 良好的施工性能。本页参数:干膜厚度 30-50 微米/道、理论涂布率 0.103 千克/平方米/40 微米、组份数 双组份。

以上内容整理自原厂说明书与本站参数表;选型、配套与货期请联系我们确认。

体积固体份—
干膜厚度30-50 微米/道
理论涂布率0.103 千克/平方米 /40 微米
VOC—
密度/比重—
组份数双组份
闪点21℃以上
稀释剂环氧稀释剂#20
混合比Base/Hardener=4/1(by weight)

按分类浏览同类型号本型号属于:面漆、环氧漆

EPOMARINE BTD环氧面漆

PRODUCT DESCRIPTION

A two pack polyamide cured epoxy finish.

产品简介

是一种双组份聚酰胺固化的环氧面漆。

RECOMMENDED USE

As a finish in epoxy paint systems can be used in steel structure at industrial

用途

moderately to severely corrosive environments. As intermediate coat for high durable topcoat.

用于中等或严酷工业腐蚀环境的钢结构表面,作为环氧涂层系统的面漆使用。

也可作为高性能面漆的中间漆使用。

FEATURES

Super tough and strong films

产品特性

漆膜强韧

Excellent impact and abrasion resistance properties

极强的耐冲击耐磨损性能

Compatible with epoxy anticorrosive systems

适合同环氧防腐涂料配套

Good workability

良好的施工性能

PHYSICAL PROPERTIES

基本数据

Color 颜色 Gloss 光泽 Volume Solids 体积固体份Colors
Flash PointGreater than 21℃
闪点21℃以上
Film thicknessDry 30-50 microns/coat Wet :65-109microns/coat
涂装膜厚干膜: 30-50 微米/道湿膜: 65-109 微米/道
Theoretical Coverage0.103Kg/m2/40 microns
理论涂覆率0.103 千克/平方米/40 微米

Practical coverage depending on surface conditions, environment, applications, etc.

实际涂覆率与表面处理, 外界环境, 施工方法等多种因素有关。

SURFACE PREPARATIONRemove salt and other water-soluble contaminants by fresh water.
表面处理用清水冲去盐份及其它水溶性污物。

Remove oil and grease with suitable detergent or solvent(SSPC-SP 1).

依照SSPC-SP1 溶剂清洗标准除去油脂。

Remove rust, mill-scale and other loose material completely by abrasive blasting.

用喷砂方式除去铁锈、氧化皮等达到ISO Sa21/2(SSPC-SP 10)或更好。

All surface to be coated should completely clean,dry and free from contamination.

涂漆前确认表面清洁干燥无灰尘。

APPLICATION

施工

Application Temperature 施工温度5℃-40℃
MixingCombine Base with Hardener, mix thoroughly with power agitator
混合混合主剂与固化剂,使用动力工具搅拌均匀
Mixing RatioBase/Hardener=4/1(by weight)
混合比例主剂/固化剂=4/1(质量比)
Pot life5℃20℃30℃
混合使用期12hrs8hrs6hrs
Application MethodsAirless spray, air spray, brush and roller
施工方法无气喷涂、空气喷涂、刷涂、滚涂 Airless spray 无气喷涂
Nozzle tip喷嘴尺寸0.33mm-0.43mm
Nozzle pressure出口压力≥10Mpa
Thinning ratio稀释比率0-5% by volume(体积比)

Brush/Roller 刷涂、滚涂 Thinning ratio 稀释比率 5-10% by volume(体积比)

ThinnerEpomarine Thinner #20
稀释剂环氧稀释剂#20
Drying time & Overcoating intervalDrying time & Surface dryDrying time & 指触干燥5℃ 4hrs20℃ 2hrs30℃ 1hr
干燥时间&涂装间隔Touch dry半硬干燥30hrs16hrs8hrs
Min. interval最小涂装间隔30hrs16hrs8hrs
Max. interval最大涂装间隔
Typical undercoatEPOMARINE EX-500,r according to the coating system of Cosco Kansai.
适用下涂 Typical topcoat 适用上涂环氧漆EX-500 或参考我司涂装配套

STORAGE

Store in dry, cool condition and away from sources of heat and ignition. Containers

贮存

must be kept tightly closed.

贮存于干燥阴凉的环境中,远离热源及火源。包装桶必须保持封闭。

Shelf life12 months from date of production (25℃)
贮存期限自生产之日起12 个月(25℃)
SAFETY PRECAUTIONSDetail information is given on MSDS.
安全措施详细信息参见化学品安全说明书。

Avoid inhalation of spray mist or vapour.

避免吸入漆雾或蒸气。

Avoid skin and eye contact.

避免接触皮肤和眼睛。

Paint contacted with skin should be immediately removed with water and/or suitable cleanser. Eyes should be flushed with water and seek immediate medical attention.

如果油漆接触到皮肤,应用温水以及(或者)适当的清洗剂清洗。如果油漆 接触到眼睛,应用大量水冲洗并立即就医。

Since this product contains flammable solvents, keep away from sparks and open flames.

因为产品中含有挥发性溶剂,避开火花和明火。

Application and handling of this product should be in compliance with relevant national regulations.

使用本产品应遵守相关国家安全规定。

DISCLAIMER

The information given on this sheet is to the best of our knowledge and accurate at

提请注意

the time of issuing. Since conditions of use are beyond the manufacturer’s control, information contained herein is without warranty, implied or otherwise, and the suitability of the material for the use contemplated is the sole responsibility of the buyer. The information contained on this data sheet is subject to modification at any time due to our policy of modification and product development.Please check this date sheet is current prior to using the product.

本说明书所提供信息均为目前我方所掌握最全面正确的资料,鉴于产品使用条 件非我方所能控制,此中信息不含担保,即仅在选取产品上对买方负责。由 于我公司产品及生产工艺的不断发展,本说明书的内容也会随时进行更改, 此中所有信息均以我方确认为主。产品使用前,请确认所持说明书为最新版 本。

资料以厂商最新版为准,具体以原厂最新 TDS 为准。查看 关西 KANSAI EPOMARINE BTD 环氧面漆 原厂 PDF 说明书全文。

同品牌相近型号 · 面漆、环氧漆

查看 关西 KANSAI 全部型号

采购与资料

原厂包装规格与批次交期以实际供货为准,可联系我们按项目核算。