RETAN 6000 VARNISH 17比3 属聚氨酯漆，作面漆使用。A varnish based on acrylic polyol resin and polyisocyanate hardener & INTENDED USES 产品简介多元醇树脂与多异氰酸酯组成的聚氨酯清漆。本页参数：体积固体份 52 ± 2%、理论涂布率 0.039 kg/m2。同品牌同类可对比：ACRIC SC 丙烯酸面漆、RETAN 6000 VARNISH 聚氨酯清漆6000、RETAN 6000 聚氨酯6000 面漆。
以上内容整理自原厂说明书与本站参数表；选型、配套与货期请联系我们确认。
| 体积固体份 | 52 ± 2% |
|---|---|
| 干膜厚度 | 20μm/道 |
| 理论涂布率 | 0.039 kg/m2 |
| VOC | — |
| 密度/比重 | — |
| 组份数 | — |
| 闪点 | 17℃以上 |
| 稀释剂 | 聚氨酯稀释剂 |
| 混合比 | 主剂/固化剂=17/3(重量比) |
RETAN 6000 VARNISH
| Retan 6000 Varnish | 聚氨酯清漆6000 |
|---|
A varnish based on acrylic polyol resin and polyisocyanate hardener
| & INTENDED USES 产品简介 | 多元醇树脂与多异氰酸酯组成的聚氨酯清漆。 |
|---|
● Excellent durability in chemicals and oil
极好的耐化学品和耐油性能
● Excellent gloss and color retention
良好的保色、保光性
● Good applicability
良好的施工性能
● Provides hardeners, abrasion resistance
漆膜坚固,耐磨损
● Drying fast
干燥迅速
| 基本数据 Color(s) | Clear |
|---|---|
| 颜 | 色透明 |
| Mixing ratio | Base/Hardener=17/3 (by wt.) |
| 混合比率 | 主剂/固化剂=17/3(重量比) |
| Solids content 重量固体份 | 52±2 % |
| Film thickness | Dry : 20 microns/coat Wet : 39 microns/coat |
| 涂装膜厚 | 干膜: 20μ m/道湿膜: 39μ m/道 |
| Spreading rate | Theoretical: 0.039kg/ m2/20 microns |
| 涂覆率 | 理论值 : 0.039 千克/平方米/20μ m |
Practical: Various depending on surface conditions, environment, applications, etc.
实际值 : 与表面处理, 外界环境, 施工方法等多种因素有关。
| Shelf temperature 储存温度 | -10℃-40℃ |
|---|---|
| Shelf life | 1 year |
| 储存期限 | 1 年 |
| Flash point | Greater than 17℃ |
| 闪点 APPLICATION DATA 施工数据 | 17℃以上 |
RETAN 6000 VARNISH
| Temperature (℃)温度 | 5 | 10 | 20 | 30 | |
| Pot life (hrs) | 混合使用期 | 8 | 6 | 5 | 3 |
Airless spray, air spray, brush and roller
无气喷涂、空气喷涂、刷涂及辊涂
| Airless spray | 无空气喷涂 | Recommended 推荐 |
| Nozzle tip | 喷嘴尺寸 | 0.017-0.023 |
| Fluid pressure | 出口压力 | 100-150kg/cm² |
| Thinning | 稀释比率 | 0-10% by wet(重量比) |
| Thinner | Retan Thinner |
|---|---|
| 稀释剂 | 聚氨酯稀释剂 |
| Application temperature 施工温度 Drying time & Overcoating interval 干燥时间&涂装间隔 | -10℃-40℃ |
| Temperature (℃) | 温度 | -5 | 5 | 10 | 20 | 30 |
| Dry to touch (hrs) | 指触干燥 | 6 | 3 | 2 | 1 | 1 |
| Dry hard (hrs) | 半硬干燥 | 24 | 16 | 12 | 10 | 6 |
| Min. interval (hrs) | 最小涂装间隔 | 30 | 24 | 20 | 16 | 12 |
| Max. interval (days) | 最大涂装间隔 | - | ||||
| 涂装配套 Preceding coat | Epomarine EX 500, Super EX 21 AC, Retan Undercoat, or according |
|---|---|
| 适用下涂 | to the coating systems of Kansai. |
Epomarine EX 500, Super EX 21 AC, Retan Undercoat, 或参考我司 推荐配套。
The primer surface should be clean, dry and free of all contamination.
底漆表面应清洁干燥,无污物。
Observe the overcoating intervals specified for the primer.
注意施工时与底漆的涂装间隔。
| SAFETY PRECAUTIONS 安全措施 | A health and safety data sheet for product is available upon request. |
|---|
RETAN 6000 VARNISH Minimum precautions to be taken in dealing with all paints are:
任何油漆施工中均应保证提供以下措施:
● Avoid skin and eye contact.
避免接触皮肤和眼睛。
● If paint comes into contact with the skin , wash with warm water and/or a suitable cleanser. If paint comes into contact with the eyes, flush with copious amount of water and seek immediate medical attention.
如果油漆接触到皮肤,应用温水以及(或者)适当的清洗剂清 洗。如果油漆接触到眼睛,应用大量水冲洗并立即就医。
● Ensure good ventilation.
保证良好的通风。
● Paint products contain flammable materials. Please keep them away from sparks and prohibit any smoking in the vicinity.
涂料中含有可燃物质。请远离火花并禁止在临近地区吸烟。
● Observe all health and safety data on the container.
现场遵守一切健康安全规定。
The information given on this sheet is to the best of our knowledge and
accurate at the time of printing. Since conditions of use are beyond the manufacture’s control, information contained herein is without warranty, implied or otherwise, and the suitability of the material for the use contemplated is the sole responsibility of the buyer. The information contained on this data sheet is subject to modification at any time due to our policy of modification and product development.
本说明书所提供信息均为目前我方所掌握最全面正确的资料,鉴于 产品使用条件非我方所能控制,此中信息不含担保,即仅在选取产 品上对买方负责。由于我公司产品及生产工艺的不断发展,此中所 有信息均以我方确认为主。
资料以厂商最新版为准，具体以原厂最新 TDS 为准。查看 关西 KANSAI RETAN 6000 VARNISH 17比3 原厂 PDF 说明书全文。
原厂包装规格与批次交期以实际供货为准，可联系我们按项目核算。
